I have a D-Link DI-624, but I think this might apply to any gear.

I prefer the security and reliability of a wired connection, and use the
radio only occasionally.  Otherwise, the radio is turned off via the
vendor's software.  I have all the right stuff set up for the available
security: encryption, new password, MAC filters, new IP addresses, ho hum.

Yesterday, I started Kismet to watch the on-going ownership war for channel
six among four neighbors.  I was surprised to find a very strong signal
booming in on channel six: a/p with bssid = "default", no encryption,
sending long messages over and over, no client connected.

I eventually realized it was my DI-624.  It had gone berserk, lost all of my
custom settings, loaded the factory defaults (aka, stupid mode) and was
babbling away trying to find some UPnP devices to get acquainted with.
Meanwhile, my local network was open to all those around.

Lessons learned:

* If your router software supports writing a copy of your custom settings to
your hard drive, use it.  I did, and it saved me a lot of repair time.

* Turn off UPnP unless you need it.  From what I saw, this feature chomps
bandwidth better used in other ways.

* Be aware that your router may reinvent itself without warning.  Running a
software firewall on each machine is a pain, but good insurance.

As soon as my D-Link warranty expires, I'm gonna add a baby toggle switch to
cut power to the radio chip and avoid another surprise.

Roby

Roby <r***@no-address.net> wrote in
I cant break out the linux box everytime...

whats a good wifi sniffer for win

Repeater clients need direct access to router?
Hot spot detection
Wireless Sharing of Dialup Internet Connection?
Linksys WAG54G drops DSL connection
Clueless newbie questions
WPA/WEP random key generator
PC Screen Output to TV via Wifi
westell 327W and DI-524 together
Where can I download petition form to install WiMAX tower???
Routing problem with two network cards