|
pc
newsgroups
|
|||||||||||||||||||||||
|
|||||||||||||||||||||||
HDD noise
raptor HDD? I have two fans in the front and thought the noise was from one of them. Computer is a little over a month old, using two raptors. It only happens on start up when the machine is cold. If I shut down and boot up again the noise is gone. Doesn't seem to hurt anything but it's annoying. Rudy Try to get a new drive, it is under warranty.
Boba Vancouver Show quoteHide quote "Rudy Kazuti" <rudyk***@comcast.net> wrote in message news:leGdnXWsjfxnLM3fRVnyvA@giganews.com... > Has anybody experienced a whining noise similar to a bad fan from a WD > raptor HDD? I have two fans in the front and thought the noise was from > one > of them. Computer is a little over a month old, using two raptors. It only > happens on start up when the machine is cold. If I shut down and boot up > again the noise is gone. Doesn't seem to hurt anything but it's annoying. > Rudy > > Inside of some of the models of the hard drive assembly, there is a hard
carbon contact that is resting under pressure against the end of the spindle shaft. I have seen where this contact starts to resonate, and thus cause a noise that is similar to a bearing noise. This is very rare, but does happen. All it would take is a slight difference in the pressure of the spring metal that is holding this carbon contact to the spindle shaft. Not all drives use this technique. There are a number of ways in the design to accomplish this contact system. The purpose of this contact is to prevent static electricity, or any type of electrical transients to form on the surface of the disk platters. If this happens, the data can be effected. A more common cause of noise from the hard disk, is bearing defects, or failure. I have seen a disk drive with noisy bearings work for a number of years before it failed. I have seen others, only last a few hours. Sometimes bearings can get noise when there is a very slight offset in the match between a bearing or more, and the shaft or bushing that they are sitting in. This offset just has to be a few microns. If the natural resonance of this offset is matched to the frequency effect of the spinning of the drive, then it can make some noise. In most cases this type of noise is harmless, but annoying. If there is an actual failure of the bearings, and the noise is being caused by the disk shaft having some wobble, then there may be some noise.With time, this wobble effect will eventually get worse, because a breakdown of the bearing or bushing surfaces is occurring. If a bearing goes too far offset, a seizure in the shaft or bushing can take place. A bearing can actually have a binding effect at its points of surface contact. This can lead to one of many types of failure conditions that can occur in a hard drive. The noise in a drive can change with the temperature. This has to do with the expansion and contraction effects of the parts being effected. Personaly, if I had a noisy drive, I would get it changed... -- JANA _____ "Rudy Kazuti" <rudyk***@comcast.net> wrote in message Has anybody experienced a whining noise similar to a bad fan from a WDnews:leGdnXWsjfxnLM3fRVnyvA@giganews.com... raptor HDD? I have two fans in the front and thought the noise was from one of them. Computer is a little over a month old, using two raptors. It only happens on start up when the machine is cold. If I shut down and boot up again the noise is gone. Doesn't seem to hurt anything but it's annoying. Rudy If the noise was there all the time I would probably say it's a side-effect
of using 10'000 rpm drives. But because you say it stops once the drive is warm I would suggest that one of your drives is perhaps faulty. A slight issue you have is that at the consumer level you are unlikely to get an advance replacement direct from WD, at best you would have to return the drive and wait for a replacement (could take up to 14 days here in the UK) However some retailers have an advance replacement scheme set up with drive manufactureres so if you bought your system from a helpfull retailer you may be able to get a replacement drive without having to return yours first. On Mon, 04 Apr 2005 18:56:51 +0100, Wayne Stallwood
<myname@digimaticDOTplus.C0M> wrote: >If the noise was there all the time I would probably say it's a side-effect for that I have a good solution on my site under comp/mods .. :-)>of using 10'000 rpm drives. -- Show quoteHide quote˛˛ ˛˛ Regards , SPAJKY ® \\.//_. mail addr. @ my site @ http://www.spajky.vze.com \°/ ".. long live & prosper.." - 3rd Anniversary running it: || "Tualatin OC-ed / BX-Slot1 / inaudible setup!" False alarm. The noise is there all right but it's coming from an old WD
6gig I put in a removable tray for backup. I isolated it today. Now I have to see if it's the drive or the little fan on the back of the tray. Mabey I'll yank it and just put a zip in. Thanks for the help. Rudy Show quoteHide quote "Wayne Stallwood" <myname@digimaticDOTplus.C0M> wrote in message news:42517e62$0$94541$ed2619ec@ptn-nntp-reader01.plus.net... > If the noise was there all the time I would probably say it's a side-effect > of using 10'000 rpm drives. But because you say it stops once the drive is > warm I would suggest that one of your drives is perhaps faulty. > > A slight issue you have is that at the consumer level you are unlikely to > get an advance replacement direct from WD, at best you would have to return > the drive and wait for a replacement (could take up to 14 days here in the > UK) > > However some retailers have an advance replacement scheme set up with drive > manufactureres so if you bought your system from a helpfull retailer you > may be able to get a replacement drive without having to return yours > first.
Alternative to Individual.NET
Well Now That I Got Blood All Over The Place Rebates going way of the dodo? noisy fan AMD64 and Windows CPU Usage (and temp) SATA saga - resolved extigy drivers cd AMD1800+ upgrade to AMD64-939 would a system with 400 DDR RAM installed, refuse to work on a 266/333 mobo? PS2 Mouse problems on A7N8X Deluxe |
|||||||||||||||||||||||